CHOP CULT HOME
Email Password
Search

Thread: Detailing.

  1. #1

    Default Detailing.

    A little premature, but I did a little detailing. Stainless fasteners don't look the best straight off the shelf, so I've started neatening them up a little. Allen heads have striations on the side of the heads and numbers stamped on the face of the heads, so I chucked a heap of them and turned them down a little before polishing. Hex heads were very rough, so they were ground down a little before polishing. I ground and polished the ends of any bolts that were seen as well as removing the excess thread..
    I've only done one side of the bike, tomorrow I'll tackle the other. Then the engine fasteners, a few little ones on the carbs. I haven't done the washers, can't figure out how to hold them without polishing the ends of my fingers.
    The footpeg holes to which I mount the mufflers are 12mm, heads of the fasteners on the inside looked like they'd scrape against the swingarm, so I turned up some brass shim tubes and pressed them into place so I could use 10mm fasteners, they just clear the swingarm.
    Once I've finished, I'll remove the clear coat and just leave the ally bare.
    Attached Thumbnails Attached Thumbnails WIN_20220915_11_19_11_Pro.jpg   WIN_20220915_11_22_09_Pro.jpg   WIN_20220915_11_29_40_Pro.jpg   WIN_20220915_11_22_24_Pro.jpg   WIN_20220915_11_23_11_Pro.jpg  


  2. #2

    Default

    More.
    Attached Thumbnails Attached Thumbnails WIN_20220915_14_11_34_Pro.jpg   WIN_20220915_14_10_37_Pro.jpg   WIN_20220915_14_12_30_Pro.jpg   WIN_20220915_14_23_32_Pro.jpg   WIN_20220915_14_32_34_Pro.jpg  


  3. #3
    Senior Member

    Content on this page requires a newer version of Adobe Flash Player.

    Get Adobe Flash player


    Join Date
    Oct 2016
    Posts
    241

    Default

    Looks great Toglhot, I can only imagine the hours that go into it.

Share This



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in