If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone have a trick to mount a flat side 42 Mikuni to an S&S manifold? How did you get around the oil feed, etc. Thanks
The answer was easy, skip the rubber boot, go with the high flow aluminum mount, cut off the push side of the throttle linkage and throw your wallet at it.��
Does anyone have a trick to mount a flat side 42 Mikuni to an S&S manifold? How did you get around the oil feed, etc. Thanks
The answer was easy, skip the rubber boot, go with the high flow aluminum mount, cut off the pull side of the throttle linkage and throw your wallet at it.👍
Tweet
Comment