Looking for information on how to convert final drive from belt to chain on a 81 cowpie,
I have purchased appropriate sprockets and a bearing brace. The brace doesn’t fit properly I’m going to assume because of the longer shaft.
Anyone have information on how to do this properly? Is a shaft swap the only way?
If it’s too much work for now, is there a brace to buy to run with an open primary and final belt drive?
Thanks!
I have purchased appropriate sprockets and a bearing brace. The brace doesn’t fit properly I’m going to assume because of the longer shaft.
Anyone have information on how to do this properly? Is a shaft swap the only way?
If it’s too much work for now, is there a brace to buy to run with an open primary and final belt drive?
Thanks!
Comment