Hey all, first post here.
I’ve been working on building out my chopper 2012 sportster. I’ve just recently built out the wiring harness from scratch, which was loads of fun, and now I’m focused on the brakes.
I’m running no front brake, only rear, and there’s currently no brake lines or master cylinder… its the way i bought it. No brakes basically.
I’m good running brake lines and doing that whole thing, but I can’t seem to find how to wire-up a brake switch from scratch, or if there is a kit for that... I would prefer not to use the cheap-o spring powered brake switch that attaches to the brake rod, but I will if that’s the deal.
Any help is appreciated.
I’ve been working on building out my chopper 2012 sportster. I’ve just recently built out the wiring harness from scratch, which was loads of fun, and now I’m focused on the brakes.
I’m running no front brake, only rear, and there’s currently no brake lines or master cylinder… its the way i bought it. No brakes basically.
I’m good running brake lines and doing that whole thing, but I can’t seem to find how to wire-up a brake switch from scratch, or if there is a kit for that... I would prefer not to use the cheap-o spring powered brake switch that attaches to the brake rod, but I will if that’s the deal.
Any help is appreciated.
Comment