If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a set of 3/8 aluminum hard oil lines for the panhead but I'm having clearance issues. I was wondering if I can use 1/4 copper and bend it myself. Are there any issues from reducing the tubing size?
Yes, there is an issue: flow. Stick to the 3/8 size. And I hope your lines are cad plated steel, and not aluminum. Aluminum lines may not survive the vibration.
Tweet
Comment