Edlund Frames (Sweden) Dragstews US East Coast Dist.

[Tattooo]

I think $2500 for those frames isn't bad at all.........

[Davestune]

Yeah, they are very nice, hard to find oem frames that are not messed up.

[Dragstews]

Edlund been busy .....

Here's a 46 Knuck "Bullneck" frame that he just got done building ....

[shank1kole]

Hey Drags, got any frames left? perhaps with a 45 degree rake? for the "hair dryer" build we have began speaking about

[Dragstews]

No problem ...

Man, that's a lot of rake ... You may have the need to tag that scooter in two states ..

[DoomBuggy]

Guess I should post here as I have one of their stock straight leg Panhead frames half way through the paint process right now. Welds were super clean, I molded this frame and I only had to clean three or four of them that had a small bulge before I hit it with the glass. Everything fit properly, with a couple of light finishing touches.

So the only things I had to finish were, the holes for the belly pan, the zerc fitting hole on the brake cross over, the hole for the neck lock retaining pin, and I had to do a little bit of clean up the hole where the speedo cable goes through the neck casting.

I could not be happier with it and can't wait to get the Panhead back together.

Edit: Here is the completed bike:

[Dragstews]

... /// https://youtu.be/EaY6y02XH_Q \\\ ...