Finishing up on my 98 evo sport chopper. Rewired the whole bike. Installed new Ultima Dual Fire Ignition - Dual Fire/Single Coil set up. Wires are all ran through frame. Using 12g cloth covered copper wire. Correct ohms Coil. Bike turns over but no fire and the red LED light on the new ignition has a steady blink. Instructions says:

"If the status LED flashes rapidly when the engine is not running, an over-current or short circuit fault is indicated."

I've looked over everything twice and can't figure the issue. I'm also aware I still have to time the bike but I was thinking I had to have the bike running do to the timing??