I'm building a 98" Shovel bobber and trying to use these 2001 Buell forks - was planning on cutting/slugging them to lower about two inches... I think it is going to look tough as shit and ride pretty well after all is said and done.
Any ideas on the following:
1. Can you run these as dual front brakes? I bought it with just the one caliper and master cylinder, but the lower fork legs look like it would run/support duals?
2. Anyone know the size (mm) so I can rebuild them properly, etc..
thanks all,
cs
Any ideas on the following:
1. Can you run these as dual front brakes? I bought it with just the one caliper and master cylinder, but the lower fork legs look like it would run/support duals?
2. Anyone know the size (mm) so I can rebuild them properly, etc..
thanks all,
cs
Comment