I'm trying to keep this bike as "legal" as possible, because california can be a little too sensitive sometimes when it comes to motorcycles. I figured I'd share this, since there's plenty of us who hate the look of standard signals. These are tiny LED's from superbrightleds.com. After trimming my fender and adding an early tail light, I drilled a couple holes near the edge of the fender, and pushed these in from inside the fender. These little f'ers are bright.
Last edited by bforbes; 07-31-2011 at 1:26 AM.
Couldn't notice where they were until I got down to the last photo.
Will they care that your number plate light shines up into the sky?.
Tell them it's the motherships signaling light and it's to guide you into warp 9.
Got ya. What about the disabled plate?
Does it give you certain perks?
Like discounted registration or can you park in the disabled parking spaces etc.
Sorry about the questions, I not from around these parts.
Never seen one before.
What do those run? I'm constantly looking for the right lights- NY is a real pain in the ass about that stuff- are they simply on off or do they have dual brightness ones? Like what a marker/turn signal would be
These things are really inexpensive. Here's the link. http://www.superbrightleds.com/cgi-b...mini_tubes.htm
They are just turn signals, at least on my bike. They are off until I hit the button, and then they blink. I'm not sure if they have a running light option. That sight has tons of light options.
The handi plate is because I broke my feet a while back, and it hurts to walk long distance everyday. I work at studio lots, and the parking is always really far away, and the plate allows me to park next to my office. Bikes aren't normally allowed on the lots.
yo, says they have 'Miniature and Sub-miniature sizes available'. which did you get?
also says they have built in capacitors for 12v. this mean you can run them without any kind of signal booster thing?
those are cool you can barley see them. If I have to have signals that is definitly the way to go.
those are bad ass, got one more question, what seat is that?
Thanks for the tip on these lights. going to grab a couple and try to fit them under the chrome top shock caps. I'll post pictures if it works.
The seat was done by dan at OldGoldGarageCo , but it set me back from my bars a bit too
much so I had it built up a bit and re-covered.
hey man, did you need a voltage regulator or just wire it into existing harness?
It's wired into the existing harness, but I did replace my turn signal module with a badlands load equalizer in order to run led's.