CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: Bruce

Search Forums: Search took 0.01 seconds.

  1. That adds a lot of clarity, thank you! I think...

    That adds a lot of clarity, thank you! I think the preference will be to stick with a 16" wheel. My one concern is the brake cover to frame clearance. It's about a 1/4" at the moment. Also if I move...
  2. Bolt on hardtail rear wheel offset and tire size

    I'm helping out a friend with a 1969 T120/1971 frame with a bolt on hardtail.

    Triumphs are not my area of expertise. I'm welding on tabs and other general fab work for them. Lots of work to do,...
  3. Replies
    40
    Views
    3,848

    Do you have this PDF manual? >> Harley-Davidson...

    Do you have this PDF manual? >> Harley-Davidson Sportster 1986-2003 Service Manual
    It's pretty easy to find online, but I can also send you a download link no problem.

    The engine installation...
  4. Replies
    40
    Views
    3,848

    Looks Good!! Almost ready to roll.

    Looks Good!! Almost ready to roll.
  5. Replies
    40
    Views
    3,848

    Seems like that little 'dip' is common. Mine has...

    Seems like that little 'dip' is common. Mine has it too, but the tank covers it up no problem. You probably know this, but just make sure your motor is bolted up tight according to the manual...
  6. Replies
    10
    Views
    1,074

    106523 I then split the thinner part were its...

    106523

    I then split the thinner part were its joined (arrow)... inside behind the neck, if that makes any sense. Then kept working down the welds with grinder, and peeling back the gusset with a...
  7. Replies
    10
    Views
    1,074

    When I decided to pull off the factory gussets,...

    When I decided to pull off the factory gussets, there was not a lot of info out there on how to proceed. So here's a few thoughts and pics, in case anyone wants to go this route. First of is why? The...
  8. Replies
    10
    Views
    1,074

    Thanks! It's been a boatload of work so far...but...

    Thanks! It's been a boatload of work so far...but fun. I blew my budget and bought a Motogadget m-unit basic. I've re-wired and wired a number of bikes. It's a pretty straightforward deal, but lots...
  9. Replies
    10
    Views
    1,074

    I really have no idea at the moment. I'm going to...

    I really have no idea at the moment. I'm going to run it bare metal for a bit and see how it goes. I sort of have a hankering for a white bike though, but then drift over to a light blue. Either way,...
  10. Replies
    3
    Views
    513

    I had to extend my stand after installing 4" over...

    I had to extend my stand after installing 4" over tubes. I cut the kickstand mount and moved it up the rail so the end would be in the stock location just under the primary. The bumper was long gone...
  11. Replies
    10
    Views
    1,074

    92 Sportster Hardtail Build

    I thought I would join the growing legion of Sporty chops and post my on going project. I'm about mid-way through the build, looking at Spring 2022 for completion. I'll post my progress over the...
Results 1 to 11 of 12

Log in

Log in