CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: drivermark

Page 1 of 5 1 2 3 4

Search Forums: Search took 0.01 seconds.

  1. Custom Chrome Transmission on Craigslist

    Saw this on Portland CL https://portland.craigslist.org/mlt/mpo/d/gresham-harley-transmission/7527371051.html
    Are these transmissions any good? I haven't heard anything about these and was curious...
  2. Replies
    8
    Views
    477

    This might help ...

    This might help


    https://chopperbuildershandbook.com/springer-measure.html
    https://chopperbuildershandbook.com/mockups1.html
  3. The Riddle of the Sands by Erskine Childers ...

    The Riddle of the Sands by Erskine Childers Adventure, intrigue, sailboats.
    Almost anything by Vince Flynn.
  4. Replies
    8
    Views
    762

    That's pretty cool, I like how that turned out.

    That's pretty cool, I like how that turned out.
  5. Put in new bearing, tightened up the clutch hub...

    Put in new bearing, tightened up the clutch hub to 120ft.lb (with the reinforcing ring for the weak spot at the keyway.
    Seems to be working ok now, it doesn't make that god awful crunching sound...
  6. Thanks Jim, I have actually made one of...

    Thanks Jim,

    I have actually made one of those little reinforcement rings, which is why I tried to tighten the hub nut tighter ( 100 ft.lb.)but as mentioned it didn't take up all the slop I was...
  7. I thought I was having problems with starter- 85 softail

    Turned ign. switch to run, engaged manual solenoid lever. Engine starts to turn over then starter acts like it hit spot with no teeth, a bit of a grinding sound and acting like it is spinning but not...
  8. Replies
    39
    Views
    2,508

    Thanks Jim, I'll keep that in mind for future...

    Thanks Jim, I'll keep that in mind for future reference.
    I did find this on condensers while surfing the net a while back it might be helpful for some
    http://www.nonlintec.com/sprite/cap_failure/...
  9. Replies
    39
    Views
    2,508

    "Apparently the convenience of points is to be...

    "Apparently the convenience of points is to be able to buy parts anywhere"

    That and the stock electronic ignitions are programmed to have 3 dead revolutions before they fire the spark plugs...
  10. Replies
    39
    Views
    2,508

    Jim has a write up for timing cone shovels and...

    Jim has a write up for timing cone shovels and iron heads if you haven't seen it, it is here:

    https://www.chopcult.com/forum/showthread.php?t=55778
    Hope this helps and maybe saves Jim some...
  11. Replies
    0
    Views
    308

    Reading Material

    Stumbled across this, thought maybe some here would find interesting, a lot of shit to dig through but there are some gems in the list.


    https://u1lib.org/s/motorcycle?

    The sight limits you...
  12. Replies
    19
    Views
    1,801

    A bigger gas tank, saddle bags to hold the beer...

    A bigger gas tank, saddle bags to hold the beer (or whatever) and a decent tool kit as mentioned above. Run about 15-20psi in that rear tire and ya should be good to go. I've heard guys say pack...
  13. Replies
    12
    Views
    583

    That's a killer looking bike, and I've always...

    That's a killer looking bike, and I've always been kind of partial to the look of springer forks.
  14. I have one of those lever solenoids on my softail...

    I have one of those lever solenoids on my softail and the "gasket" that came with it was just a little circle of sticky backed open cell foam that wouldn't stop anything from leaking, but I have...
  15. Replies
    12
    Views
    583

    From the Chopper builders Handbook article titled...

    From the Chopper builders Handbook article titled "FrontForks"

    link to article
    https://chopperbuildershandbook.com/forks.html



    There are some facts and then there are also some myths...
  16. Replies
    4
    Views
    434

    The one I posted above is a free service so how...

    The one I posted above is a free service so how good it is IDK but it might be useful for research purposes.
  17. Replies
    4
    Views
    434

    https://www.nicb.org/vincheck

    https://www.nicb.org/vincheck
  18. Replies
    5
    Views
    550

    http://virtualindian.org/8blueprints.htm ...

    http://virtualindian.org/8blueprints.htm

    There is a sketch for a clutch pedal+ other stuff that may give you some ideas good luck let us know how it turns out.( I also have a 2000 sporty I was...
  19. Open Primary w/ Chain and '85-'89 style Clutch

    I really like the look of an open chain primary but the 85-89 is a "wet" clutch from the factory, what would I need to change to run an open chain primary?
    Would it be as simple as changing the...
  20. Replies
    335
    Views
    519,092

    Sticky: I may or may not have posted this one here yet...

    I may or may not have posted this one here yet but this link has a whole shitload of stuff

    http://forums.sohc4.net/index.php?topic=17788.0
  21. Now I like that story:cheersmate:

    Now I like that story:cheersmate:
  22. Replies
    11
    Views
    1,045

    Wish I could help but I have nothing to offer but...

    Wish I could help but I have nothing to offer but condolences and much respect.
  23. Replies
    9
    Views
    907

    Nothing wrong with an 80 inch, I got one myself...

    Nothing wrong with an 80 inch, I got one myself but with the aftermarket evo motors coming out at up to140+cubes and the MOCO making what 114- 125 ci stock motors an 80 incher is getting smaller...
  24. Thread: Thank you!

    by drivermark
    Replies
    27
    Views
    5,802

    Sticky: +1 Thank you for all the hard work

    +1 Thank you for all the hard work
  25. Damn good idea thanks

    Damn good idea thanks
Results 1 to 25 of 103
Page 1 of 5 1 2 3 4

Log in

Log in