CHOP CULT HOME
Email Password
Search

Search Forums:

Type: Posts; User: Skjoll

Page 1 of 14 1 2 3 4

Search Forums: Search took 0.04 seconds.

  1. Replies
    14
    Views
    290

    It sounds like you're really interested in the...

    It sounds like you're really interested in the Dyna... I say go take it for a test ride.
  2. Yea it looks like a 5.00/100-16. In addition to...

    Yea it looks like a 5.00/100-16. In addition to Coker's own model like the Classic there's the Indian Script and Beck brands that I think are distributed by Coker... there's also the Shinko 270,...
  3. Replies
    8
    Views
    493

    Tight isn't good enough... check for corrosion...

    Tight isn't good enough... check for corrosion between neg terminal and the frame. Also check all the ends of both pos and neg terminals... the cables can fray under the heat shrink tubing due to...
  4. Thread: Fork clunk

    by Skjoll
    Replies
    8
    Views
    439

    I'm not sure they'll listen to a complaint where...

    I'm not sure they'll listen to a complaint where there's no photo evidence of a defect. I had pictures of scratches and pits that developed so they kinda had to listen but I doubt they'd be open to a...
  5. Dielectric grease on the terminals and then a...

    Dielectric grease on the terminals and then a short length of an appropriate diameter bicycle inner tube stretched over the housing and running out the back for a few inches to cover the wires is one...
  6. Replies
    2
    Views
    318

    That's sage advice. Decades ago long before the...

    That's sage advice. Decades ago long before the internet I sometimes had to rely on Chilton, Clymer and Haynes manuals and found that the info wasn't always accurate, especially when it came to...
  7. Thread: Fork clunk

    by Skjoll
    Replies
    8
    Views
    439

    I had no problems with them sending me a...

    I had no problems with them sending me a replacement set of fork tubes, they were good in that respect but they never even bothered verifying that the replacements they sent me were within spec and...
  8. Replies
    186
    Views
    20,095

    Have you come up with a solution for lengthening...

    Have you come up with a solution for lengthening the drive shaft?
  9. Thread: Fork clunk

    by Skjoll
    Replies
    8
    Views
    439

    There's a good chance that the TC Bros/Moto Iron...

    There's a good chance that the TC Bros/Moto Iron forks are out of spec by a few thou. I had that problem with two sets of Moto Iron fork legs I got and even with brand new seals and bushings their...
  10. Replies
    20
    Views
    7,766

    I like riding all over North America on my bikes...

    I like riding all over North America on my bikes and one of the best parts of road tripping is setting up camp at the end of a long day and inspecting/maintaining the machine that has just carried my...
  11. Replies
    189
    Views
    28,518

    That's not CC's fault, it's because of your...

    That's not CC's fault, it's because of your phone/camera settings and how the image capture app writes the EXIF data that other apps such as browsers use to display pictures... entirely your...
  12. Replies
    8
    Views
    473

    A picture is worth a thousand words so here...

    A picture is worth a thousand words so here goes... I assume you mean item #3 in the diagram.

    https://estore.chester-harley-davidson.co.uk/img/sip/110117.jpg
  13. I'm also 6'3" but with a relatively short 33"...

    I'm also 6'3" but with a relatively short 33" inseam (a fairly tall guy but with dwarf proportions :D) however my Sporties aren't lacking in the fit department. The ergos on one is set up so my arms...
  14. Replies
    48
    Views
    1,794

    As much as that scenario sucked, IMO it'll be a...

    As much as that scenario sucked, IMO it'll be a good thing in the end because not only may you learn painting skills but I think the less you farm out work on a build, the more the bike becomes YOUR...
  15. Replies
    37
    Views
    6,574

    There appears to be too much preload and as...

    There appears to be too much preload and as JBinNC mentioned you need to cut the spacers down. Also your forks seem to have very little rebound damping and that could be caused by either not enough...
  16. Replies
    10
    Views
    336

    It's because of your phone or camera settings...

    It's because of your phone or camera settings regarding capture, display and screen rotation. That determines what the device writes in the image's EXIF file and how that data is interpreted by other...
  17. Replies
    48
    Views
    1,794

    I like what your doing with the bike but was...

    I like what your doing with the bike but was compelled to finally point out that the oil line feeding the oil pump makes me uneasy. Trochoid oil pumps are great for creating pressure but they don't...
  18. Replies
    10
    Views
    494

    Is that a serious or rhetorical question?...

    Is that a serious or rhetorical question? Apparently you're new to choppers/customs but your 'question' could be interpreted as trolling sarcasm, a form of comedy for which I have great respect.
  19. The snow and ice from a week ago has melted......

    The snow and ice from a week ago has melted... now we have typical late Winter/early Spring time flooding to deal with here in The Loo....
  20. Replies
    159
    Views
    31,002

    LOL... rene53catalina, I can sympathize... but...

    LOL... rene53catalina, I can sympathize... but the best lessons learned are from failures... right?

    In the mid-80s I worked at a chrome-plating biz. I learned a great deal about plating in the...
  21. Replies
    49
    Views
    2,053

    But just remember, no matter the topic, wetness...

    But just remember, no matter the topic, wetness is the most important concern. ;)
  22. Replies
    10
    Views
    416

    Here in KY you can only get Antique or Historic...

    Here in KY you can only get Antique or Historic plates for vehicles that meet an age requirement BUT aren't normally driven/ridden and are used primarily for exhibitions or parades. Sure you can...
  23. Replies
    7
    Views
    334

    Damn you MOTher, I was going to mention that...

    Damn you MOTher, I was going to mention that 'hack'. ;) You can also fab a set using modern sportbike triple bottoms that fit the sliders (my fave type of brace... the one that tzienlee posted a pic...
  24. Replies
    49
    Views
    2,053

    CDeeZ, first off props to you for being so...

    CDeeZ, first off props to you for being so thorough, astute and resourceful. I watched your vid (with the WB02) multiple times using a high end Sennheiser studio headset and honestly, the bike sounds...
  25. Replies
    49
    Views
    2,053

    As JBinNC mentioned that can occur due to...

    As JBinNC mentioned that can occur due to harmonic reversion and the sound pulses travel from the exhaust side to the intake manifold during valve overlap and out to the carb mouth and then reverse...
Results 1 to 25 of 339
Page 1 of 14 1 2 3 4

Log in

Log in