King n Queen Seat 4 Sale

Here is a nice & narrow king n queen for a rigid frame bike. Very clean and ready to use.This seat has the perfect shape right over your fender and up the sissybar.Email me for details@

Comment with Facebook


Comment with Chopcult (0)

Please Login to Comment

Recent Blogs

Random shots from the Long Beach Cycle Swap / July 2014

Random shots from Long Beach 
...photobombed again

Cool battery placement.

Ride for Larry Pierce NJ / NY Details

On Saturday August 9th. We are going to host a ride to honor the memory of our friend Larry Pierce. This is open to anybody and everyone. If you want to stop by for five minutes or stay the whole day, it is Okay either way. We are going to meet up at the SHOP starting around noon. We will hang out a bit, compliment each others choice of foot pegs, then ride to LADY JAYS in Brooklyn. Miles will be serving BBQ and running Drink Specials all day long. As an added bonus there will be Motorcycle only parking right in front. Simple fun to be had for everyone. Check out for more details and see all the people from around the world, getting together for this great thing. Here is a link to get you to the right place. DIRECTIONS.


New product from Bung King

New chain tensioners available for 05 and earlier dynas and FXR's from Bung King. These are 3 times thicker than stock to reduce distortion keep your axle where you want it under harsh riding conditions. Available now through their website

tt500 build : part 13

While taking my time getting the motor back together, I decided to try and get some of the smaller stuff checked off my to do list. The rear tire has been installed, and while doing so I noticed the bearings were locked solid. No movement at all. I tried to remove them by my usual method with a hammer and drift, but no go. Heat and penetrating fluid didn't make a difference. I found a thread on the sr500 forum that said to use a 5/8" concrete anchor bolt as a blind bearing puller. For less than $2, why not right?

Shove the bolt and sleeve through the bearing leaving the nut and washer facing out. Grip the sleeve with a pair of channel locks or vice grips and tighten the nut. Once things are nice and snug tap the bolt from the other side with a drift until they drop out. The first bearing on the brake side came out nice and easy, but when attempting to remove the second one, the sleeve got tweaked. Luckily I bought two.

I decided to try and pull two from the sprocket side at a time and see if that would be easier. They slid out like butter. That gave me enough room to knock the stubborn brake side one out with a drift.

All done with new bearings and seal from All Balls. Notice my 5 gallon pickle bucket under the wheel? It has a fancy Irwin tool organizer that was gifted to hold my tire and bearing service tools. I know you can by the wheel stands, but this thing doesn't take up much room, works great, and best of all was free. Changing tires is easier than one would think, and bearings can just drop in the bucket instead of chasing grease soaked parts across the floor or bench.

I've also been replacing a few seals here and there as well as some worn out hardware. Countershaft seal, clutch actuator and seal, clutch adjuster assembly, countershaft nut and locking washer. Currently the tx750 forks are apart for new seals and a general cleaning. More on those soon.

Cycle Parts..Part 3

Nos Webco cast aluminum license plate bracket/light and old set of 1" Triumph Pre Unit handlebars. Killer bend and narrow center. Step down throttle too. Email me for details

More Cycle Parts For Sale

21 " skinny wheel 36 hole 21x1.4 wheel small hub. NOS Wassell non ribbed fender(black) NOS Wassell aluminum ribbed fender. NOS stainless British fender. Email me for details@
Share This



Advertise    |    Contact    |    ©2009ChopCult    |    Report Abuse    |    Conduct

Chopcult on Facebook