I am back at the wiring. Time to connect the headlight to the handlebar switch.
I use a little rosin on the wire, then light crimp, then solder. My alligator clip holder
works here as well as doing straight connections.
A little shrink wrap on the connectors and some where the wires come out of the bars.
There's not enough room for my usual Dorman 85612 connectors
so I will have to go with a male spade terminal on the headlight wires. And yes, I did solder on a foot of wire to these leads last time, just used like two inches of the new wire.
This is exactly why I use those covered double male connectors. Just look at all that metal showing.
Connect and cover the metal with electrical tape.
Hide everything with spiral wrap.
I am getting happier about how this is coming along.
Looking fairly clean.