If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
if you are trying to run a cast aluminum one sometimes the bottom of the cases is not even where the two half's go together, you may have to go back to the old stamped steel one and use lots of gasket sealer.
ryan's trying to be all unique with his love for the 500.
he wants a pre unit so bad it's disgusting.
It's so disgusting, I just threw up alot!!!
Yeah, because I want a bike that leaks even more oil with no end in site!
Let me know how fun it is to take the motor out and put it back in,
500 rule and you are just to affraid to admit it
It's so disgusting, I just threw up alot!!!
Yeah, because I want a bike that leaks even more oil with no end in site!
Let me know how fun it is to take the motor out and put it back in,
500 rule and you are just to affraid to admit it
let me ride your 500 and i'll tell you what's good.
Well, I want to stop by on my bike and this time I'm going to try and not leak on your cement. Then I'll drag race Ryan for pinks and pee on his shoes when he's crying because I'm loading his bike in my truck.
Then I'll take his bike and modify the frame so it can hold a proper 650 engine.
Comment