Troy Fab
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
Thanks Chopcult for the Chop Market
Troy Fab specializes in designing and fabricating Basic Builder Parts. Just parts for people who do not have access to a fabrication shop. I am slowly building a Standard Product Line that can be seen on my website.
E-mail is:
[email protected]Last edited by Guest; 11-22-2010, 4:22 PM. -
Triumph Speedo Spacer Hubs
Fill the void were where your old speedo drive used to be. 6061 aluminum.
$38.00 Shipped Cont. USA
E-mail [email protected]
Comment
-
Last edited by TroyFab; 08-21-2017, 8:24 PM.Comment
-
Last edited by TroyFab; 08-21-2017, 8:28 PM.Comment
-
New Dogbone Design, Chain Tensioner
New Dogbone Design!
Bolt-on Chain Tensioners:
Fits Triumph Bolt-on Hardtails and other hardtail frames with 1″ tubing. Bolts to 1″ bottom frame cross tube. Slides left to right and pivots up and down. 15 Tooth “MADE IN USA” Idler sprocket (SEALED BEARING), This is for 530 chain.
Sold sand blasted and ready to paint, powdercoat or chrome.
$75.00 Shipped
Comment
-
Triumph Speedo Spacer Eliminator
New Pricing! $38.00 Shipped Cont USA
Replace your unused speedometer drive sitting on your rear axle for a nice clean look. Fits 1963 - 1970 Triumph motorcycles. After you remove the old speedo; this spacer slides right on and fits over the grooved ring in your rear hub.
Last edited by TroyFab; 08-24-2017, 4:21 PM.Comment
-
Now Selling Taillights to go with my Taillight Backs!!
Stainless Taillight - 28-31 Model A Style
Made of polished stainless steel with glass lens. Light has lense on the bottom to illuminate a license plate. 12 volts. 4″ diameter, 3″ depth, 3″ height.
These taillights have two bulbs in them, that are of a single filament style.
$40.00 Shipped Cont. USA
Last edited by TroyFab; 08-24-2017, 4:27 PM.Comment
-
troy fab
good product at a fair price, doesent hesitate at a refund if its not what you needed. cant beat that in this craft. thanxComment
300 mobile ad bottom forum
Collapse
Comment