I just installed a hunt mag on my 52 pan. Had to sand down a ton of material from the relay mount. I had to take a little off the bottom of the mag body too because it was rubbing on the generator. There's just a C-hair clearance now.
Right now I'm unable to install the mag on its post with the distributor cap on the mag. Since it's impossible to install the one cap screw while the mags on the bike I take it that enough material has to be removed from the cylinder fins so that the mag can be installed with the cap already screwed on
Someone's already pushed up one of the cylinder head fins for a little clearance
Am I right thinking that I've gotta grind down those cylinder fins and install with the cap on? Anyone have some input for me?
Right now I'm unable to install the mag on its post with the distributor cap on the mag. Since it's impossible to install the one cap screw while the mags on the bike I take it that enough material has to be removed from the cylinder fins so that the mag can be installed with the cap already screwed on
Someone's already pushed up one of the cylinder head fins for a little clearance
Am I right thinking that I've gotta grind down those cylinder fins and install with the cap on? Anyone have some input for me?
Comment