I want to stretch my rear of the bike out. And I have a shaft. Is it possible to get the shaft machined and add an extra three inches or so to it?
im doin mine right now. i didnt use to drive shafts though. just cut mine in half. turned some round stock to size and welded it in. took some tubeing, drilled holes in it(for plug welds) then cut it in half length-wise. and welded it all together on the shaft. a lot of welding but that bitch is bullet proff and straight.
make shure you balance it too. you do want those negitaves vibes hitting you
there is a driveshaft place were i send all my truck shafts that do awsome work. the can make it any size you whant and balance it for not allot of cash.
its a local plave here in quebec canada but if you go to any garage or transmission place they should be able to tell ya were to send it