I'm just about finished with my project bike. Its a 78 hard tailed frame with a shovel in it. I have a 2 inch belt drive, but I'd like to swap it for a 1.5". The issue I have is belt tension.
I use an original inner primary to align the engine+transmission. Both of the belt drives I have are BDL. Using the inner primary leaves the 2" belt pretty loose and the 1.5" belt will barely go on. It's very tight.
Is there a way I can set these up with regular garage tools?
I use an original inner primary to align the engine+transmission. Both of the belt drives I have are BDL. Using the inner primary leaves the 2" belt pretty loose and the 1.5" belt will barely go on. It's very tight.
Is there a way I can set these up with regular garage tools?
Comment