If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
81 fxe, kick only, points. Bare minimum wiring(no turn signals, no horn etc.) What coil should I be using? 5 ohm or 3 ohm? Any suggestions on what’s a good brand?
Thank you!
For a points and coil ignition, you want a 5 ohm coil. A 3 ohm coil draws too much current and that burns points.
The Dynatek coils have always been good, and I also use & sell the Andrews 5 ohm coil. Only had one failure that I know of, in dozens sold over the years.
Comment