I gotta get rid of these forward controls so I'm trying to figure out how to install my mids, the pegs are already on and I have the brake lever, I've got the shift side worked out. what I cant figure out is how to connect the master cylinder to the lever. Its simple but I overthink things and just trying to make sure I'm doing this right.
My bike doesnt have the stock style master cylinder with the seperate reservoir. So I was gonna get a sportster one or similar, if that kind will work and mount it where the stock one goes. One problem my exhaust mount is in the way. I may be able to remove it and put the bolt through and then put it back on though.
Could I just put the MC on with one bolt if I need to? Also the linkage, I need this kind to fit my lever:
If I bought this style master cylinder with this linkage would it work? In my head it looks like it'll work but without the measurements I'm not sure. Also should I buy a used MC or a new one?
Or if anyone's got any other ideas I'd appreciate the help
Thanks in advance!
My bike doesnt have the stock style master cylinder with the seperate reservoir. So I was gonna get a sportster one or similar, if that kind will work and mount it where the stock one goes. One problem my exhaust mount is in the way. I may be able to remove it and put the bolt through and then put it back on though.
Could I just put the MC on with one bolt if I need to? Also the linkage, I need this kind to fit my lever:
If I bought this style master cylinder with this linkage would it work? In my head it looks like it'll work but without the measurements I'm not sure. Also should I buy a used MC or a new one?
Or if anyone's got any other ideas I'd appreciate the help
Thanks in advance!
Comment