Hey everyone, I’m back and looking for more help. I’m running a banjo bolt brake switch on my front master cylinder but I keep tripping the breaker when engaged(if that’s what it’s called, it resets its self after). I’ve attached a picture of my current wiring, I hope it’s clear and can help. As noted in the picture I currently have wires labeled Red#2 and Orange#2 running to the banjo bolt, I haven’t soldered anything yet so if I need to run different wires I can.
A couple things to note about the picture.
If wires don’t go anywhere they are literally not going any where currently. If it’s labeled hot it’s a hot wire once the ignition is turned.I have re wired the starter to start with the 3 position IGNITION switch so the green wires coming off the stater currently go no where.
Finally, on to the headlight, I WAS going to run the Orange#2 to power it’s self and the banjo bolt but I assume I can’t do that if it can’t handle the banjo bolt already. I thought about using the Dark blue but it runs to the same breaker. Any advice on this?
Finally, when things are wrapped up what do I do with leftover wires? Cut, and heat shrink them so they don’t arc to anything?
Any help is greatly appreciated!!
Comment