on/off switches HELP

Collapse

Desktop Ad Forum Top

Collapse

Mobile ad top forum

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • MvaladAo
    Junior Member
    • Mar 2017
    • 29

    on/off switches HELP

    I'm cleanging up the OL handle bars...
    took the switches apart to pull the wires and what not. BUT the wires connect to a circuit breaker! so i cant figure out what wire goes where...
    I have the wiring diagram. but it doesn't say or make any sense. i tried to chase them back to under stand, but i cant figure it out.

    i've seen a lot of people do this. but i cant find any information on it..
    also i got a switch with a three prong I I I, to a push button with two prong I I... i figured it was the same as on the switch housing..
    any help would be great!!!!

    2016 HD 883 iron x
    Attached Files
    Last edited by MvaladAo; 01-28-2020, 10:26 PM.
  • TriNortchopz
    Senior Member
    • Dec 2017
    • 3245

    #2
    You didn't say what bike...can I see 2004 Sportster on the bottom of the one wiring diagram?
    If buildin' old school choppers was easy, anyone could do it... ain't nobody said it's gonna be easy...

    Comment

    • confab
      Senior Member
      • May 2019
      • 1337

      #3
      In the first pic, I see "Can Hi" and "Can low"

      Is this a CAN Buss? Do late model bikes have those?

      If so, and if that is it for the handlebar control wiring, you may be hosed. Because the processor does the work and modules communicate with it over that buss. Not the same as traditional switch wiring.

      If this is the case, your "circuit breaker" is a circuit board, and a module which uses that buss to talk to the PCM and do the work switches used to do via dedicated wiring.
      Last edited by confab; 01-28-2020, 10:18 PM.

      Comment

      • MvaladAo
        Junior Member
        • Mar 2017
        • 29

        #4
        2016 883

        Comment

        • MvaladAo
          Junior Member
          • Mar 2017
          • 29

          #5
          oof...i was hoping this wasnt the case!!! damn new wiring

          Comment

          • confab
            Senior Member
            • May 2019
            • 1337

            #6
            Originally posted by MvaladAo
            oof...i was hoping this wasnt the case!!! damn new wiring
            Is that all the wiring that is in that control? What I see in the first pic?

            There is nothing else? It isn't a partial diagram?

            If so, it is a module and it communicates over the CAN buss, and there is no dedicated wiring to splice into.
            Last edited by confab; 01-28-2020, 10:50 PM.

            Comment

            300 mobile ad bottom forum

            Collapse
            Working...
            ;