Banjo Sizes for Aftermarket Masters and Calipers

[MadRiverMoCo]

This one is buckling my brain

I need to order some banjo bolts

But I've got a clusterfuck of brake and clutch to deal with

HHI 11/16 Clutch and GMA 9/16 going into a 4 pot PM front and Hydro clutch on the primary

Got the 3/8 24 for the clutch but the banjos into the PM caliper and the GMA & HHI master cylinders is just not readily available. Yes, I can buy the Sniper 2 builder kit for brakes but I'm trying to economize.

Idears?

[JBinNC]

This is where your local independent motorcycle shop would be handy (if you have one). Drag Specialties and other distributors carry a lot of brake hardware, and I for one stock banjo bolts and fittings to adapt HD stuff to the -3AN line.

Don't know about current production, but PM always used 1/8NPT threads in their calipers.

Jim

[TriNortchopz]

hydraulic lines and fitting, incl. banjo bolts; maybe here:

https://www.venhill.co.uk/hydraulic-lines-amp-fittings/self-assembly-lines-and-fittings/powerhose-plus-banjo-bolts.html

[MadRiverMoCo]

hydraulic lines and fitting, incl. banjo bolts; maybe here:

https://www.venhill.co.uk/hydraulic-...njo-bolts.html

I know where to get them (I'm building internal Goodridge Sniper 2 lines) I just don't know the pitch and depth

I'm assuming PM is 10mm but it would be a guess that could have very expensive ramifications. Prefer to learn without expensive ramifications.