Compensating sprocket removal
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
A) That's not a compensating sprocket, it's a motor pulley.
B) The two threaded holes allow the use of a harmonic balancer puller to remove that pulley. Use a penny over the end of the shaft to protect the center. If you damage the center, you will not be able to use that shaft when rebuilding the flywheels because you won't be able to true them.
Jim -
Comment
-
A) That's not a compensating sprocket, it's a motor pulley.
B) The two threaded holes allow the use of a harmonic balancer puller to remove that pulley. Use a penny over the end of the shaft to protect the center. If you damage the center, you will not be able to use that shaft when rebuilding the flywheels because you won't be able to true them.
JimComment
300 mobile ad bottom forum
Collapse
Comment