Tweet
95 HP from a Ironhead, you believe that, not me!
-
-
Naw ...
Maybe from a 93 inch Ironhead, but not a 86 inch ... !!
This motor has a longer stroke than the Scoot in the video, but is not as big of bore..Last edited by Dragstews; 02-26-2020, 7:33 AM.Take my 45 and outrun em all ..Comment
-
Well now ....
Still in the mode of getting all the parts rounded up for this monster in the making ...
Just may be changing horses in the middle of the creek ..
Ran up on a set of Poole Jugs for building a Shovster ...
Hell Yeah ..... !!!
If we do go this route, going to be Bad-Ass ...Last edited by Dragstews; 04-24-2020, 7:33 PM.Take my 45 and outrun em all ..Comment
-
Nailed down a early CH oil tank ...
Also found a NOS racing sticker to put on it .......
"IF" this Hot-Rod Sportie turns out like I think it will .. Yeah, just might see a bit of Racing going on ...
Last edited by Dragstews; 04-24-2020, 10:24 PM.Take my 45 and outrun em all ..Comment
-
I pulled the trigger ....
This build has turned a corner ... !!
Last edited by Dragstews; 04-25-2020, 3:19 AM.Take my 45 and outrun em all ..Comment
-
Ya known what would be Super Cool and Trick for this new curve in the build ....
These .....
Aluminum Knuck Heads .. ^^
(Dual Carb-ed too)Last edited by Dragstews; 04-25-2020, 4:46 AM.Take my 45 and outrun em all ..Comment
-
Will this all fit in the frame?Comment
-
Most likely some mods will be needed ...Take my 45 and outrun em all ..Comment
-
Been awhile since a Shovster build has graced the 33 .....
Just happened to luck up on these jugs ....
....
....
Last edited by Dragstews; 04-25-2020, 2:17 PM.Take my 45 and outrun em all ..Comment
-
-Yeah .... Have them made with a Shovelhead bolt pattern and "Knuckster" here we come ...
(All Aluminum Motor too, no-mo Iron)Last edited by Dragstews; 04-25-2020, 6:52 PM.Take my 45 and outrun em all ..Comment
-
That will be the owner's choice ..
If he can get with Nickie on those heads, just might be doing a "Knuckster"
(Or a Shovster/Panster)Take my 45 and outrun em all ..Comment
-
Y'all wanta help me design a cam for running 1:1 rocker arm ratio of the Kuncks... ??
Engine specs :
86 CI
Around 9 to 9.5:1 compression ... (Still going to be a Street Bike, Kicker Only)
Getting the "Accelerator Program" warmed up to run some numbers ...
Don't be shy, speak your mind ...
Lets run this though the Acc. program ...
I can live with dat ^^ ..Last edited by Dragstews; 04-27-2020, 3:07 PM.Take my 45 and outrun em all ..Comment
-
Nevermind Guys .... I think I got this ...
Take my 45 and outrun em all ..Comment
Comment