If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Rebuilding my S&S Shovel... That was invaded by idiots at some point in time.
Going to wait till the new pistons come in...
Being this motor was built by S&S 17 years ago, there could be a difference of piston weights...
If I remember they was using TRW's back in that year, now it's Wiseco's ...
Will weigh them and make a call on what to do ....
Might need to re-balance em ... ??
So you weight both the pistons and then balance the crank to those numbers?
Jake
l'll weigh the old pistons then the new to see how close they are....
Most likely it would be a good idea to balance the flywheels anyways..
Those S&S rods are of the early design without having added weight made into the front rod recip. zone....
Comment