If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
building my 3rd Knucklehead that I got from BBQ
got motor bolted in and mounts shimmed along with skid plate.
and started reworking the inner primary tin. this roller was for my flathead so alot was done already that I did over past few years.
Here are some pics
Go a little nuts ...
(Well, a little more nuts !!)
I here ya, i just like 3.5 gallons and able to ride 500 miles eat and ride on....
You guys with pans and shove are so lucky, all i have is knuckleheads
good for you Dave. I still think you got the better deal in the trade. if you have space problems i'm ok with you storing(or donating) one of them at my house.
good for you Dave. I still think you got the better deal in the trade. if you have space problems i'm ok with you storing(or donating) one of them at my house.
Be careful, If Farmall sees this post he might come at ya. Or are you taking lessons from him lol.
Need a ton of small stuff.
Comment