If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Parts still being listed on Ebay as 25mm to fit 1" handlebars!!!
22mm handlebars are not really 22mm either, they are 22.2 something, or 7/8". I would think they are 1" though, since metric 25mm pipe is made in smaller volumes and therefore more expensive.
22mm handlebars are not really 22mm either, they are 22.2 something, or 7/8". I would think they are 1" though, since metric 25mm pipe is made in smaller volumes and therefore more expensive.
Pipe is for poop. Pipe is measured by internal diameter(volume) and is meant to contain pressure. Tubing is measured by external diameter and meant for structural.
Pipe is for poop. Pipe is measured by internal diameter(volume) and is meant to contain pressure. Tubing is measured by external diameter and meant for structural.
Makes fuck all difference if its called a pipe or a tube when im welding it😄 25mm od pipetubes are still smaller volumes and more expensive than the very common 1" od pipetube, so no point in selling expensive shit that dont fit anywhere..
Makes fuck all difference if its called a pipe or a tube when im welding it 25mm od pipetubes are still smaller volumes and more expensive than the very common 1" od pipetube, so no point in selling expensive shit that dont fit anywhere..
If you buy a handlebar mounted component on EBay for your motorcycle and it says For 25mm or 1 inch bars.
it will not fit.
If you knurl a 25mm pipe you get the extra 0,4mm.. but after first bump it will start to loosen up, best to use the addecuate size of tubing, and also tubing is cheaper then pipe
If you knurl a 25mm pipe you get the extra 0,4mm.. but after first bump it will start to loosen up, best to use the addecuate size of tubing, and also tubing is cheaper then pipe
This thread is NOT about pipe or tube .
It is about Chinese components that will not fit American motorcycle with 1 inch handlebars.
This thread is NOT about pipe or tube .
It is about Chinese components that will not fit American motorcycle with 1 inch handlebars.
Still a completely useless scam since 1" pipe is cheaper than metric. The Chinese are many and stupid, and the world would be better if they had zero industrial production.
Still a completely useless scam since 1" pipe is cheaper than metric. The Chinese are many and stupid, and the world would be better if they had zero industrial production.
In America it is cheaper. Everywhere else in the world metric is cheaper. That's why the Chinese make 25mm stuff. If 1" OD tube/pipe was cheaper they'd use that. It isn't cheaper. The rest of the world ain't the United States of America.
HaHa! Nice try.
Hey your build is coming along nicely. Can't wait to see it running.
Thanks Hillcat! Today I will get the wiring put away since it all checks out, and install the gas tank.
Then I can finally actually try to start the engine.
Comment