If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When cutting down a cam cover, does this hole need to be plugged back up and how would be the best way to do so? The hole leads up to the bushing I circled in white.
Yes, that is your main oil gallery. I have drilled and tapped for either a 1/16NPT or 1/8NPT tapered pipe plug. Install with loctite after final cleaning before assembly on the motor.
Or, you can weld it up as it was originally.
Comment