Triumph pre-unit engine build

[britbikebuilder1]

Zeeman I am not sure of the brand of the ignition housing , it was left over from one of our race bikes. The Tri-Spark has a cover and the wire exits in the center where this one has a hole on the side for the wire and accepts a standard points cover.
I enlisted the help of a friend for the cylinder head so that it would be a nice press fit for the dowels I knew my chinese drill bit collection just would not make a precision hole.

[Choppedtriumphs]

I think those E/I bodies were made by a guy named Joe, the gears were made by Hal Hall, Joe sent a couple to Tyler years ago.

Nice build!