Cadillac chopper

[scottiemcdoogle]

I’m still waiting to get my seat back from upholstery but I got the bike running and was able to ride to a gas station and back without it dying. I’ll update y’all again when I get the seat. I’m also working on a bike rack for my bmx that I’m pretty excited about.

[scottiemcdoogle]

Here’s some shots of the bmx bike rack. Pretty stoked on how this turned out.

[scottiemcdoogle]

Unrelated but I also built a sissy bar for my mini bike ��

[TriNortchopz]

Looks heavy duty - anything for additional support under the fender between the bungs?

In photo #3, not sure, but it looks like your rear sprocket is out of alignment - looks like a bend in the top row of the chain, and coming off at an angle at the bottom of the sprocket?

[scottiemcdoogle]

Looks heavy duty - anything for additional support under the fender between the bungs?

In photo #3, not sure, but it looks like your rear sprocket is out of alignment - looks like a bend in the top row of the chain, and coming off at an angle at the bottom of the sprocket?

Optical illusion I think, in this picture it looks fine.

And I’ve been thinking about reinforcing the fender. Maybe just a section of 1/8” flat bar will help but not rub.

[scottiemcdoogle]

Totally forgot to update this! I’m pretty much done with the build, just working out kinks now.


Seat done by BJ’s upholstery in Irving TX

[scottiemcdoogle]

[Davestune]

Nice job, love the handle bars

[Luky]

How many degrees of rake?

[scottiemcdoogle]

How many degrees of rake?

I didn't mess with the rake, so whatever is stock on an 81 ironhead.

The forks are 31" from the bottom of the tree to the axle.

[scottiemcdoogle]

Thank you. They're zombie performance traditional 6 bends.