I'm switching to 6 over tubes on my XL 1200 Custom and replacing the seals as well. took out the axle and one of the two 6mm bolts is stripped to shit from a previous owner. based on the bolt's torque from the other tube, I'm assuming this things going to be a bitch to get out with an extractor. to clarify this is the 6mm bolt at the bottom end above where the axle slides through (holds the tube's assembly together).
Wondering am I screwed, what do you all think, and any suggestions? would be a huge help, thanks everyone
Wondering am I screwed, what do you all think, and any suggestions? would be a huge help, thanks everyone
Comment