I think $2500 for those frames isn't bad at all.........
Edlund Frames (Sweden) Dragstews US East Coast Dist.
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
Hey Drags, got any frames left? perhaps with a 45 degree rake? for the "hair dryer" build we have began speaking aboutComment
-
Guess I should post here as I have one of their stock straight leg Panhead frames half way through the paint process right now. Welds were super clean, I molded this frame and I only had to clean three or four of them that had a small bulge before I hit it with the glass. Everything fit properly, with a couple of light finishing touches.
So the only things I had to finish were, the holes for the belly pan, the zerc fitting hole on the brake cross over, the hole for the neck lock retaining pin, and I had to do a little bit of clean up the hole where the speedo cable goes through the neck casting.
I could not be happier with it and can't wait to get the Panhead back together.
Edit: Here is the completed bike:
Last edited by DoomBuggy; 04-30-2022, 5:27 PM.Comment
-
300 mobile ad bottom forum
Collapse
Comment