Trying only run rear turn signals

[seansatfoh905]

I bought a Kuryakyn LED kit with the turn signals built in. I've chopped both front a rear signals. I don't have any intention of using front signals again, so what do I need to do to make the rear signals flash correctly?

This is on a 1997 XL1200C

Cheers

[Tattooo]

I bought a Kuryakyn LED kit with the turn signals built in. I've chopped both front a rear signals. I don't have any intention of using front signals again, so what do I need to do to make the rear signals flash correctly?

This is on a 1997 XL1200C

Cheers

The flasher doesn't know how many lights you have.... Wire it just like you have four lights without the two front...

[Tattooo]

By the way this is the How to tech section. Not the how do I section...

[usmc50lx]

I bought a Kuryakyn LED kit with the turn signals built in. I've chopped both front a rear signals. I don't have any intention of using front signals again, so what do I need to do to make the rear signals flash correctly?

This is on a 1997 XL1200C

Cheers

the flasher module shouldn't care about load like a mechanical flasher, so like tattoo said wire it all like normal, if nothing else you can wire LF and LR together and RF RR together and use a resistors to trick it into thinking it has a load like a regular bulb.