80 - 80" Rigid cone shovel

[Jeremy24]

I started a thread a while back for this bike but have changed directions so I just started a new thread on it. 80- 80' cone shovel in a rigid frame. 4 speed roatry top trans, bdl open primary, 39mm front end, -2 under with shaved lowers, no front brake. The hub is 2 sportster hubs that we cut in half and then welded back together to eliminate the brake side of the hub, laced to a 21' wheel, 5 inch ribbed fender, yadda yadda yadda

[Jeremy24]

fitted up the heads, pipes and a few other things last night

[BlackCloudSalvage]

Looking good

[Jeremy24]

took the spray gun for a spin. Im new to paint but its turning out well, wet sanded it out last night, ill post some pics later after I hit it with a medium cut compound.

[Jeremy24]

Updating progress

Few more nights assembly and it'll be ready to wire and fire.

[image1]

that's looking sharp!

[Bbqbiker]

Lookin good! Like the apes better personally......

[Davestune]

[ATTACH=CONFIG]75842[/ATTACH]

took the spray gun for a spin. Im new to paint but its turning out well, wet sanded it out last night, ill post some pics later after I hit it with a medium cut compound.

great job.............

[DIABOLUS]

Nothing quite like building a bike from the comfort of the inside of your home.

[Jeremy24]

Nothing quite like building a bike from the comfort of the inside of your home.

I know right, the wife is cool with it too bc she gets to spend more time together that way haha

[BHMike]

I know right, the wife is cool with it too bc she gets to spend more time together that way haha

My wifes the same way . Bikes looking killer

[Jeremy24]

My wifes the same way . Bikes looking killer

Thanks, ill post up some more pics tonight, hopefully get the clutch and belt drive installed tonight

[Jeremy24]

Almost there. ill finish the wiring this week and it should be shake down time

[Jeremy24]

sorry flipped pic

[Jeremy24]

Shot from the back and the side