i am rebuilding my 60 panhead motor and the flywheel pinion shaft has some end play. when the gear cover is on with a gasket, the big nut on the flywheel scrapes the inside of the case. if i assemble it without the gasket, everything spins fine. are there shims for the pimion shaft that i am missing? i cannot find any reference to them in any parts books. im thinking of just sealing it up without the gasket if i cannot find the shims. any suggestions would be helpful?
panhead flywheel shaft end play
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
Crank is a five piece built-up unit....
The sprocket shaft Timken bearing controls the end play...
If you have abundance end-play the smallest washer in the match kit can be surface down to attain 0.001 to 0.003 end-play...Last edited by Dragstews; 03-30-2016, 6:01 AM.Take my 45 and outrun em all ..
300 mobile ad bottom forum
Collapse
Comment