CHOP CULT HOME
Email Password
Search
  1. #1

    Join Date
    Sep 2015
    Posts
    2

    Default Zuki Intruder Question

    Just got my first bike recently and have been tinkering on it to make it mine.

    In the process of swapping stock bars for drag-bars (7/8") I managed to sheer a bolt on the OEM riser.
    Was going to replace the 140$ part but found that the drag bars hit the tank on full left and right movement.

    The solution was to buy new, taller, aftermarket risers instead but finding risers with internal wiring is near impossible; internal is the stock wiring method.
    So instead I could go to the more traditional external wiring but my stock "top tree plate" (not sure of proper vocab) has massive holes for the internal wiring risers so I would need to replace it I assume.
    Need guidance on sourcing possible parts.

    TL : DR - Need to source internal wiring 6" risers or a new triple tree plate for '96 Zuki Intruder

    Thanks in advance and Progress Pictures for your time!
    -Phrate
    Attached Thumbnails Attached Thumbnails 20150912_120340[1].jpg   20150915_185918[1].jpg   20150929_183334[1].jpg   20150930_001530[1].jpg  
    Last edited by Phrate; 09-30-2015 at 7:13 PM.

  2. #2

    Join Date
    Sep 2015
    Posts
    2

    Default

    Shameless self bump

  3. #3
    Senior Member

    Content on this page requires a newer version of Adobe Flash Player.

    Get Adobe Flash player


    Join Date
    Jan 2011
    Posts
    810

    Default

    just run the wires on the outside, make sure they arent getting pinched or stretched and have some kind of covering on them (electrical tape) and you will be fine.

    Unless you WANT internal wiring, in which case you just need to get creative. If you have a friend that has a drill press a solution should be pretty simple.

  4. #4
    Senior Member

    Content on this page requires a newer version of Adobe Flash Player.

    Get Adobe Flash player


    Join Date
    May 2010
    Posts
    1,147

    Default

    I don't know of any risers made for the 1400 intruder that allow for internal wiring other than stock ones. But your bars are 1", and not 7/8". Did you sheer the bolt on the top of the riser clamp?

Share This



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in