Tweet
So a friend of mine wanted to run an internal throttle with a 7/8 clipon bar, I made him this one. It's an Ultima internal throttle assembly that has had some parts remade allowing it to bolt into any clipon body with removable 7/8 bars.
It's extra long and can be cut to any length, no welding required for installation. Material for the bar is 304SS, so no need to paint.
I don't think this is a product that exists anywhere else. If the demand is there, I'd make a few more. Price would probably be around 125 dollars, but I'm not going to bother pursuing it unless there is interest.
One of the downsides with internal throttles is that they are PULL only. Be aware of this.
Also I may be able to make 7/8 internal throttles for putting on normal 7/8 bars, but haven't pursued that.
It's extra long and can be cut to any length, no welding required for installation. Material for the bar is 304SS, so no need to paint.
I don't think this is a product that exists anywhere else. If the demand is there, I'd make a few more. Price would probably be around 125 dollars, but I'm not going to bother pursuing it unless there is interest.
One of the downsides with internal throttles is that they are PULL only. Be aware of this.
Also I may be able to make 7/8 internal throttles for putting on normal 7/8 bars, but haven't pursued that.