CHOP CULT HOME
Email Password
Search

Threaded View

  1. #1

    Default Broken case...going to take some creativity to fix

    Anyone ever run across this problem? Pulled the inner primary on dad's old FXR to reseal everything. It's been leaking forever between the engine case and the inner primary. Well, this is why... the piece was still there, but it was cracked to the point of it falling off as soon as I touched it.



    I think I am going to take it to work and see if we can mount it on the mill. If I'm careful, it might even be able to be done without tearing the motor down very far. I want to mill a circle around where the lip should be and cut it about 1/4" deep or so. Then hopefully make a new one from aluminum and press it in place.

    If that don't work...
    Last edited by TimberwolfFXDL; 04-19-2015 at 3:51 PM.

Share This



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in