Looking rad
Build: Softail Bobber
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
-
-
-
Battery installed, oil lines installed, engine oil, transmission lube... Starter test, bendix engages and disengages properly, starter spins engine, oil pump primed, oil flowing through engine.
These are the lines of this scoot... little will change as the project is completed.Comment
-
-
-
Close to first ride... chain installed:
Use correct tool when installing riveted master link:
D.I.D. 530VX Gold/Black X-Ring chain.Comment
-
-
Comment
-
GMA 4-piston rear brake operational... bleeder valve was defective, temporarily replaced with plug. D.O.T. 5 silicone brake fluid used, Galfer D520R stainless rear brake line.
Comment
-
-
Scoot is back on the lift... preliminary break-in complete, oil/filter change, cleaned tappet oil screen. Now to shorten excess wire length, work towards completing build, decide what needs to be changed.
Comment
-
Installed standard length (24-1/4") FXST fork tubes and rubber gaiters. Needed to increase corner clearance... dragging Jiffy Stand in left hand corners. Liked the low, short-bike look, but longer forks provide more clearance in corners.
Comment
-
-
Rattle-can Satin Black over rattle-can self-etching primer... utility paint for a utility build.
Comment
300 mobile ad bottom forum
Collapse
Comment