If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Done a bit more, a heap more parts have turned up, engine top end sent away for porting port matching benched flowed and compression taken to 11:1. Allballs 1.4kw starter in, transmission drive shaft chain sproket on and the open primary belt is going back on. Will set the rear ended up next week
Not a long of progress has been made. I work away a lot and some times when I'm home a got a lot on. Got the swing arm on and started lining up the mounts for the caliper and alining the chain drive
Comment