Wiring a panhead
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
Tags: None
-
what kind of ignition are you using ?
you would wire the coils according to the instructions that the particular ignition module calls for -
-
this is a stock points setup. With stock coil and a second coil for a dual plug setup (four spark plug wires and 4 plugs). There is absolutely no marking on any of the coils so I'm thinking of wiring it up just like in the diagram above but not sure how to wire up the second coil that I have.Comment
-
Easy, Wire the first coil like stock or like your diagram
then steal power from the power post of the first coil, run it to the power post of the second coil
Same with the signal wire, from points to first coil signal post then on to second coil signal post.Comment
-
ok cool. Thanks. So it's sort of a parallel setup.Comment
-
It's more or less the same as you'd do with a Dyna S. Here's a link to how it's wired
Comment
-
Comment
300 mobile ad bottom forum
Collapse
Comment