Oi! Three steps forward, four back.
Turned my back when the bike was on the stand to grab a socket and sure enough it fell hard on its side. I didn't have the pegs on, so I bent my shifter shaft. Replaced it thinking I found all the damage only to find the bars bent good. Damn!
Decided to tear the frontend down and do the springer. Glad I did. I like it this way. It's a Paughco with ThreeTwo Choppers wishbone front legs. I had to shorten both the front/rear legs, make risers for the drag bars, caliper mount, upgrade brakes ect, ect and then powder it all. Seems like it took forever between work trips. To top it off, I dropped the headlight this morning shattering the lens. Sheesh!
Anyway, here are a couple pics:
Before it fell:
After:
Turned my back when the bike was on the stand to grab a socket and sure enough it fell hard on its side. I didn't have the pegs on, so I bent my shifter shaft. Replaced it thinking I found all the damage only to find the bars bent good. Damn!
Decided to tear the frontend down and do the springer. Glad I did. I like it this way. It's a Paughco with ThreeTwo Choppers wishbone front legs. I had to shorten both the front/rear legs, make risers for the drag bars, caliper mount, upgrade brakes ect, ect and then powder it all. Seems like it took forever between work trips. To top it off, I dropped the headlight this morning shattering the lens. Sheesh!
Anyway, here are a couple pics:
Before it fell:
After:
Comment