CHOP CULT HOME
Email Password
Search
  1. #1
    Junior Member

    Content on this page requires a newer version of Adobe Flash Player.

    Get Adobe Flash player


    Join Date
    Dec 2012
    Posts
    21

    Default Running Spool Hub Triumph Front End???

    I want to run a 21" spool hub on my current Build. Normally you would center the hub then lathe up some spacers to center it between the forks. The catch here is the inside of the forks are round.....not flat. I'm trying to get ideas or see what others have done. Any advice or ideas are greatly appreciated!

    attached is a photo of my forks
    Attached Thumbnails Attached Thumbnails Triumph Fork Legs.jpg  

  2. #2
    Trinda
    Guest

    Default

    what's keeping you from tossing some spacers in a mill and cutting the ends of the spacers the OD of the fork tubes?

  3. #3
    Junior Member

    Content on this page requires a newer version of Adobe Flash Player.

    Get Adobe Flash player


    Join Date
    Dec 2012
    Posts
    21

    Default

    Quote Originally Posted by Trinda View Post
    what's keeping you from tossing some spacers in a mill and cutting the ends of the spacers the OD of the fork tubes?
    Mainly the mill part of the equation is holding me up

Share This



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in