A buddy's grandfather has an old trump tiger frame, engine and what I think is a slightly later set of forks that he wants to sell. I'm going to go try check it all out tomorrow but the frame is either a 48 or a 52 apparently and the motor is a pre unit tiger 100 of similar vintage.
What I would like to know is can a later or aftermarket hard tail be used on the frame? I'd like it with a little more stretch than stock, closer to the lines of a 60s frame with little to no stretch, is this possible without going to too much trouble or should I just hold out for a later bike?
Any input is greatly appreciated - Cheers!
What I would like to know is can a later or aftermarket hard tail be used on the frame? I'd like it with a little more stretch than stock, closer to the lines of a 60s frame with little to no stretch, is this possible without going to too much trouble or should I just hold out for a later bike?
Any input is greatly appreciated - Cheers!
Comment