Got the sprocket spaced today, got the seat from my leather man, and got the powder coating set up. Final lengths of correct diameter stainless exhaust pieces ordered, just waiting on the oil tank parts to show up, then we'll ALMOST be ready to tear it apart for paint.
Flying Monkey Build Thread
Collapse
Desktop Ad Forum Top
Collapse
Mobile ad top forum
Collapse
X
-
Finished oil tank sides showed up today. Killer! Got ahold of Dan about my rear tire clearance issues... apparently a 150 rear tire will NOT work, have to go to the 130, which doesn't bother me in the least. Got it on order, just gotta take my oil tank and get it welded up (I dont trust my AL welding as only get one shot at this), then it's wiring and brakes and then off to paint.Comment
-
Got the oil tank welded up today, just need the feed and return fittings (and a vent). Also got the exhaust re-welded (the upper pipe pulled on me from inadequate prep work the first go around), and the oil tank mounting brackets built. The lines are close, but are spot on after the rubber bushings are there. Got the tank in final primer, and started in on cleaning up some of the spot welds that we had holding little stuff on (like seat spring perches, rear fender brackets, etc). Will tear back down tomorrow night and start finish welding everything.
Comment
-
Comment
-
300 mobile ad bottom forum
Collapse
Comment