If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi guys..im working on a 75 cb750. what can i use for oil lines?can i get away with barbed fittings,rubber lines and hose clamps? will the oil pressure blow them right off? do i need special lines? special adapters?
Those would be fine. You don't need anything special, there's not a shit ton of oil pressure there. Just make sure you use proper Oil Lines and not something from Lowes (like I've done, hahaha)
Hose clamps get slack over time. Just check im every ful moon. My bud was showing his ass on the freeway once. Saw two guys ahead on baggers, twisted thethrottle on his cb chop and passed close one the left. Just then his line to the tank shot off and he sprayed those poor guys down with hot oil! It was fucked up.
Hose clamps get slack over time. Just check im every ful moon. My bud was showing his ass on the freeway once. Saw two guys ahead on baggers, twisted thethrottle on his cb chop and passed close one the left. Just then his line to the tank shot off and he sprayed those poor guys down with hot oil! It was fucked up.
Comment