Who has a 60-72 swingarm assembly view

[Guest]

Ive kinda pieced this swingarm,drum,axle and spacers together but sumthin aint jivin.My haynes manual does not have the exploded view.

[doppleganger87]

i might have what your looking for..gimme a bit and ill check..its my 72 iron..

[Guest]

Thanks man dont sweat it,I went back out and everything went into place.

[Guest]

O.k. Im still struggling with this thing!!!!! I put it all together and the right side spacer is tight as fuck going in,and when the axle gets to the other side its about 3/8 short of puttun in the cotter pin to the castle nut.The backing plate doesnt have an equal distance from the drum by about a 16th.does the drum drag a little?

[Newporabbit]

Aaronc sorry no help, I'm in the same boat. Running a 57-78 IH rear drum on an Evo and the brake plate does have a slight drag but I'm not sure if that's normal since I cut all my own spacers.

Really hope someone has a diagram

[Guest]

I made some headway on the brake drum end,I put what I found in the other spin drum freely thread thread.

[TBone65]

Hope this helps...

http://i655.photobucket.com/albums/uu280/TBone1965/RearDrum_Page_1.jpg

http://i655.photobucket.com/albums/uu280/TBone1965/RearFork.jpg

Let me know if you need additional pictures or Index numbers.

[Guest]

Yes that does help,thank you. My book didnt show anything on drums and I looked around still couldnt find anything.I was missin a spacer.