If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Cool little bike. I dig how you did up the Battery and shit, looks cool. How much do you trust the way you've got that "swingarm"? I wouldn't want to hit too many big bumps!
just as a safety measure you should have run a tube from the bottom of your frame at an angle twords the rear of the swingarm, triangulating it and keeping it from flexing upwards
Seems like a mono shock would achieved the same look...but in a safer manner. Seems like that bar supporting the seat would sheer after a few good bumps....unless ur Kate Moss skinny lol
Cafe bikes are supposed to be modeled after the old school race bikes. The racers of yesteryear knew that it was important to have rear suspension...this hasn't changed.
If you're going to leave it hard tailed (whats the point) then please bring some tubes down from the seat area to the rear of the swing arm. You picked the least structural point to connect the swing arm to the frame. I would cut that shit off and build a mono shock set up!
Comment